Agricultural Equipment & Farm Machinery Manufacturing worked example

Implement Weld Cost at 66% weld cost capture share: a worked example

This worked example runs the implement weld cost numbers for a tougher week than the baseline: 66% weld cost capture share instead of the typical 92%. Estimate weld cost for tillage tools, planters, loaders, frames, and attachments from weld length, cost per weld inch, capture share, and fixture setup cost.

The inputs for this scenario

  • Total implement weld length: 420 in (held at the documented default)
  • Loaded weld cost per inch: 2.85 $ / in (held at the documented default)
  • Weld cost capture share: 66 % (the input this scenario stresses; the baseline uses 92)
  • Fixture setup and inspection cost: 180 $ (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Captured weld cost = total weld length × loaded weld cost per inch × weld cost capture share.
  • Implement weld cost works out to 970 $ weld cost at these inputs, and this is the headline figure for the scenario.
  • Loaded weld cost per inch works out to 2.31 $ / in at these inputs.
  • Captured weld labor and consumable cost works out to 790 $ weld cost at these inputs.
  • Fixture setup and inspection cost works out to 180 $ at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where weld cost capture share sits at 92% and the headline result is 1,281 $ weld cost, this scenario comes in 24.29% below the baseline at 970 $ weld cost.
  • Use it when quoting fabricated implements, comparing make-versus-buy on weldments, or analyzing where weld content drives cost on a frame or toolbar. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Implement weld cost: 970 $ weld cost (headline result)
  • Loaded weld cost per inch: 2.31 $ / in
  • Captured weld labor and consumable cost: 790 $ weld cost
  • Fixture setup and inspection cost: 180 $

Run it with your numbers

  • To rerun this with your own numbers, open the live Implement Weld Cost calculator, set weld cost capture share to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.