Calibration Lab & Gauge Management worked example

Calibration Audit Readiness with audit finding severity score of 3 score: a worked example

This worked example runs the calibration audit readiness numbers for a tougher week than the baseline: audit finding severity score of 3 score instead of the typical 6 score. Score calibration audit readiness risk by ranking certificate gaps, overdue assets, traceability issues, and record-control weaknesses before an ISO 17025, IATF, customer, or internal audit.

The inputs for this scenario

  • Audit finding severity score: 3 score (the input this scenario stresses; the baseline uses 6)
  • Audit issue occurrence score: 4 score (held at the documented default)
  • Pre-audit detection score: 3 score (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Calibration audit readiness risk score = severity score × 0.40 + occurrence score × 0.35 + detection score × 0.25.
  • Calibration audit readiness risk score works out to 3.35 score at these inputs, and this is the headline figure for the scenario.
  • Audit finding severity works out to 3 score at these inputs.
  • Audit issue occurrence works out to 4 score at these inputs.
  • Pre-audit detection score works out to 3 score at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where audit finding severity score sits at 6 score and the headline result is 4.55 score, this scenario comes in 26.37% below the baseline at 3.35 score.
  • Use it when prepping for a calibration system audit and you need to prioritize which gaps to close first. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Calibration audit readiness risk score: 3.35 score (headline result)
  • Audit finding severity: 3 score
  • Audit issue occurrence: 4 score
  • Pre-audit detection score: 3 score

Run it with your numbers

  • To rerun this with your own numbers, open the live Calibration Audit Readiness calculator, set audit finding severity score to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.