Calibration Lab & Gauge Management worked example

Calibration Compliance Score with compliance impact severity score of 3 score: a worked example in calibration lab & gauge management

This worked example runs the calibration compliance score numbers for a tougher week than the baseline: compliance impact severity score of 3 score instead of the typical 6 score. Score the compliance risk of a calibration issue by weighting severity, occurrence, and detection so quality or audit teams can rank findings consistently.

The inputs for this scenario

  • Compliance impact severity score: 3 score (the input this scenario stresses; the baseline uses 6)
  • Compliance occurrence score: 4 score (held at the documented default)
  • Control detection score: 3 score (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Calibration compliance risk score = severity score × 0.40 + occurrence score × 0.35 + detection score × 0.25.
  • Calibration compliance risk score works out to 3.35 score at these inputs, and this is the headline figure for the scenario.
  • Compliance impact severity works out to 3 score at these inputs.
  • Compliance occurrence score works out to 4 score at these inputs.
  • Control detection score works out to 3 score at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where compliance impact severity score sits at 6 score and the headline result is 4.55 score, this scenario comes in 26.37% below the baseline at 3.35 score.
  • Use it when prioritizing corrective actions, building a calibration FMEA, or deciding where to focus limited audit and verification effort. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Calibration compliance risk score: 3.35 score (headline result)
  • Compliance impact severity: 3 score
  • Compliance occurrence score: 4 score
  • Control detection score: 3 score

Run it with your numbers

  • To rerun this with your own numbers, open the live Calibration Compliance Score calculator, set compliance impact severity score to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.