Ceramic, Tile & Sanitaryware Manufacturing worked example

Ceramic Drying Time at 11% dryer loading and moisture-check allowance: a worked example

Suppose dryer loading and moisture-check allowance falls to 11%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate required dryer time for green tile or sanitaryware loads based on pieces, drying clearance rate, and handling allowance.

The inputs for this scenario

  • Green tiles or sanitaryware pieces to dry: 2,400 pieces (held at the documented default)
  • Drying clearance rate: 7.5 pieces / min (held at the documented default)
  • Dryer loading and moisture-check allowance: 11 % (the input this scenario stresses; the baseline uses 15)

Working through the calculation

  • The calculation starts from the formula this tool documents: Base dryer clearance time = green pieces to dry รท drying clearance rate.
  • Required ceramic drying time works out to 355 min at these inputs, and this is the headline figure for the scenario.
  • Base dryer clearance time works out to 320 min at these inputs.
  • Dryer handling allowance applied works out to 11 % at these inputs.
  • Drying clearance rate works out to 7.5 pieces / min at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where dryer loading and moisture-check allowance sits at 15% and the headline result is 368 min, this scenario comes in 3.48% below the baseline at 355 min.
  • It converts a count of green pieces into required dryer time using a clearance rate and then inflates it by a loading and moisture-check allowance. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Required ceramic drying time: 355 min (headline result)
  • Base dryer clearance time: 320 min
  • Dryer handling allowance applied: 11 %
  • Drying clearance rate: 7.5 pieces / min

Run it with your numbers

  • To rerun this with your own numbers, open the live Ceramic Drying Time calculator, set dryer loading and moisture-check allowance to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.