Commercial Kitchen Equipment worked example

Final Inspection Load with final inspection test-bench connected load of 2.9 kW: a worked example

Suppose final inspection test-bench connected load falls to 2.9 kW. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate utility use and cost for final inspection, functional run, heat-up, water, or refrigeration checks on commercial kitchen equipment.

The inputs for this scenario

  • Final inspection test-bench connected load: 2.9 kW (the input this scenario stresses; the baseline uses 5.8)
  • Final inspection run-and-test runtime: 6 hr (held at the documented default)
  • Blended facility electricity rate: 0.15 $ / kWh (held at the documented default)
  • Equipment units inspected in the run: 42 units (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Final Inspection Load energy used = final inspection connected load × final inspection runtime.
  • final inspection load energy used works out to 17.4 kWh at these inputs, and this is the headline figure for the scenario.
  • total final inspection load utility cost works out to 2.61 $ at these inputs.
  • final inspection load utility cost per equipment unit works out to 0.06 $ / piece at these inputs.
  • hourly final inspection load utility cost works out to 0.44 $ / hr at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where final inspection test-bench connected load sits at 5.8 kW and the headline result is 34.8 kWh, this scenario comes in 50% below the baseline at 17.4 kWh.
  • It computes the kWh consumed by a final-inspection run, the total electricity cost, and the utility cost allocated to each equipment unit inspected. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • final inspection load energy used: 17.4 kWh (headline result)
  • total final inspection load utility cost: 2.61 $
  • final inspection load utility cost per equipment unit: 0.06 $ / piece
  • hourly final inspection load utility cost: 0.44 $ / hr

Run it with your numbers

  • To rerun this with your own numbers, open the live Final Inspection Load calculator, set final inspection test-bench connected load to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.