Commercial Kitchen Equipment worked example

Weld Polishing Labor at 29% finish setup, inspection, and rework allowance: a worked example

Push finish setup, inspection, and rework allowance up to 29% and the picture changes. This example computes every intermediate figure at that operating point. planning stainless weld finishing and polishing labor

The inputs for this scenario

  • stainless weld length to polish: 420 linear ft (unchanged)
  • weld polishing throughput: 75 linear ft / hr (unchanged)
  • finish setup, inspection, and rework allowance: 29 % (raised for this scenario; the documented default is 25)

Working through the calculation

  • Applying the documented formula (Base weld polishing labor = stainless weld length to polish รท weld polishing throughput) to the inputs above produces each figure below.
  • At this operating point the engine returns 7.22 hr for estimated weld polishing labor, the number this scenario is built around.
  • At this operating point the engine returns 5.6 hr for base weld polishing labor.
  • At this operating point the engine returns 29 % for finish setup, inspection, and rework allowance.
  • At this operating point the engine returns 75 linear ft / hr for weld polishing throughput.

How this compares with the baseline

  • Against the tool's baseline example, where finish setup, inspection, and rework allowance sits at 25% and the headline result is 7 hr, this scenario comes in 3.2% above the baseline at 7.22 hr.
  • It computes estimated weld polishing labor hours by dividing total weld length by polishing throughput, then adding an allowance for setup, inspection, and rework. The value of this scenario is the size of the gap it exposes: that gap, priced out over a year, is the budget you can justify spending to close it.

Results at a glance

  • estimated weld polishing labor: 7.22 hr (headline result)
  • base weld polishing labor: 5.6 hr
  • finish setup, inspection, and rework allowance: 29 %
  • weld polishing throughput: 75 linear ft / hr

Run it with your numbers

  • Every input above is editable in the live Weld Polishing Labor calculator, which recalculates instantly and can be shared with the inputs intact.

Last reviewed 2026-05-12.