Environmental Compliance, Waste & Water Management worked example

Emissions Fee Estimate at 72% fee applicability share: a worked example

Suppose fee applicability share falls to 72%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate emissions fee estimate from chargeable emissions, emissions fee rate, applicable share, and fixed environmental fees.

The inputs for this scenario

  • Chargeable emissions: 26 tons (held at the documented default)
  • Emissions fee rate: 72 $ / ton (held at the documented default)
  • Fee applicability share: 72 % (the input this scenario stresses; the baseline uses 100)
  • Fixed air program fees: 450 $ (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Variable cost = chargeable emissions × emissions fee rate × fee applicability share.
  • Total emissions fee estimate works out to 1,798 $ at these inputs, and this is the headline figure for the scenario.
  • Emissions fee per ton works out to 69.15 $ / ton at these inputs.
  • Variable emissions fee estimate works out to 1,348 $ at these inputs.
  • Fixed air program fees works out to 450 $ at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where fee applicability share sits at 100% and the headline result is 2,322 $, this scenario comes in 22.57% below the baseline at 1,798 $.
  • It calculates the total annual air emissions fee by multiplying chargeable tons by the per-ton rate and applicability share, then adding fixed air program fees. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Total emissions fee estimate: 1,798 $ (headline result)
  • Emissions fee per ton: 69.15 $ / ton
  • Variable emissions fee estimate: 1,348 $
  • Fixed air program fees: 450 $

Run it with your numbers

  • To rerun this with your own numbers, open the live Emissions Fee Estimate calculator, set fee applicability share to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.