EV Charging Infrastructure Manufacturing worked example

Final Test Takt with net available production time of 230 min / shift: a worked example in ev charging infrastructure manufacturing

This worked example runs the final test takt numbers for a tougher week than the baseline: net available production time of 230 min / shift instead of the typical 450 min / shift. Find the takt time for EV Charging Infrastructure Manufacturing — the pace, in seconds per unit, that production must hold to exactly meet customer demand.

The inputs for this scenario

  • Net available production time: 230 min / shift (the input this scenario stresses; the baseline uses 450)
  • Customer demand: 60 units / shift (held at the documented default)
  • Shifts per day: 2 shifts (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Takt time = net available production time × 60 ÷ customer demand.
  • Takt time works out to 230 sec / unit at these inputs, and this is the headline figure for the scenario.
  • Required rate works out to 15.65 units / hr at these inputs.
  • Available time / day works out to 460 min at these inputs.
  • Demand / day works out to 120 units at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where net available production time sits at 450 min / shift and the headline result is 450 sec / unit, this scenario comes in 48.89% below the baseline at 230 sec / unit.
  • Use it when balancing the final test cell to demand, deciding whether to add a parallel tester, or checking that measured test cycle time fits within takt. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Takt time: 230 sec / unit (headline result)
  • Required rate: 15.65 units / hr
  • Available time / day: 460 min
  • Demand / day: 120 units

Run it with your numbers

  • To rerun this with your own numbers, open the live Final Test Takt calculator, set net available production time to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.