Forklifts, Lift Equipment & Material Handling Vehicles worked example

Operator Cab Labor at 72% included cab labor scope: a worked example

This worked example runs the operator cab labor numbers for a tougher week than the baseline: 72% included cab labor scope instead of the typical 100%. Estimate labor cost for cab assembly, enclosure installation, operator compartment upgrades, heater kits, guarding, seats, controls, or ergonomic options.

The inputs for this scenario

  • Cab-equipped trucks or labor jobs: 14 jobs (held at the documented default)
  • Cab labor cost per job: 620 $ / job (held at the documented default)
  • Included cab labor scope: 72 % (the input this scenario stresses; the baseline uses 100)
  • Fixed cab setup or tooling cost: 850 $ (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Total operator cab labor = cab-equipped trucks or labor jobs × cab labor cost per job × included cab labor scope + fixed cab setup or tooling cost.
  • Total operator cab labor works out to 7,100 $ at these inputs, and this is the headline figure for the scenario.
  • Cab labor cost per job works out to 507 $ / piece at these inputs.
  • Variable operator cab labor works out to 6,250 $ at these inputs.
  • Fixed cab setup or tooling cost works out to 850 $ at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where included cab labor scope sits at 100% and the headline result is 9,530 $, this scenario comes in 25.5% below the baseline at 7,100 $.
  • Use it when quoting a forklift cab option, costing a batch of cab-equipped trucks, or deciding whether fixed cab tooling is justified at a given volume. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Total operator cab labor: 7,100 $ (headline result)
  • Cab labor cost per job: 507 $ / piece
  • Variable operator cab labor: 6,250 $
  • Fixed cab setup or tooling cost: 850 $

Run it with your numbers

  • To rerun this with your own numbers, open the live Operator Cab Labor calculator, set included cab labor scope to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.