Hydraulic, Pneumatic & Fluid Power Systems worked example

Cylinder Force with cylinder force input load of 50 units: a worked example

Suppose cylinder force input load falls to 50 units. This page works the full calculation at that level so you can see exactly which result moves and by how much. Calculate cylinder force for hydraulic, pneumatic & fluid power systems planning, quoting, troubleshooting, capacity review, or process improvement.

The inputs for this scenario

  • Cylinder Force input load: 50 units (the input this scenario stresses; the baseline uses 100)
  • Cylinder Force load factor: 1.2 x (held at the documented default)
  • Cylinder Force operating time: 8 hr (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Cylinder Force load = input load × load factor.
  • Total load works out to 60 units at these inputs, and this is the headline figure for the scenario.
  • Hourly equivalent works out to 7.5 units / hr at these inputs.
  • Input load works out to 50 units at these inputs.
  • Load factor works out to 1.2 x at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where cylinder force input load sits at 100 units and the headline result is 120 units, this scenario comes in 50% below the baseline at 60 units.
  • It computes the total cylinder load from an input load and load factor, then expresses that load as an hourly equivalent over the operating time. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Total load: 60 units (headline result)
  • Hourly equivalent: 7.5 units / hr
  • Input load: 50 units
  • Load factor: 1.2 x

Run it with your numbers

  • To rerun this with your own numbers, open the live Cylinder Force calculator, set cylinder force input load to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.