Mining Vehicle & Underground Equipment worked example

Maintenance Interval at 7.2% setup, handling, and delay allowance: a worked example in mining vehicle & underground equipment

Suppose setup, handling, and delay allowance falls to 7.2%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate maintenance interval for mining vehicle and underground equipment using production-ready inputs so teams can plan labor hours, schedule the work, or check whether the job fits the available shift time.

The inputs for this scenario

  • Maintenance interval workload: 120 units (held at the documented default)
  • Maintenance interval completion rate: 12 units / min (held at the documented default)
  • Setup, handling, and delay allowance: 7.2 % (the input this scenario stresses; the baseline uses 10)

Working through the calculation

  • The calculation starts from the formula this tool documents: Base maintenance interval time = maintenance interval workload รท maintenance interval completion rate.
  • Required maintenance interval time works out to 10.72 hr at these inputs, and this is the headline figure for the scenario.
  • Base maintenance interval time works out to 10 hr at these inputs.
  • Maintenance interval allowance applied works out to 7.2 % at these inputs.
  • Maintenance interval completion rate works out to 12 pieces / min at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where setup, handling, and delay allowance sits at 10% and the headline result is 11 hr, this scenario comes in 2.55% below the baseline at 10.72 hr.
  • It computes the required maintenance task time by dividing the workload by the completion rate to get base time, then inflating that by a setup-and-delay allowance. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Required maintenance interval time: 10.72 hr (headline result)
  • Base maintenance interval time: 10 hr
  • Maintenance interval allowance applied: 7.2 %
  • Maintenance interval completion rate: 12 pieces / min

Run it with your numbers

  • To rerun this with your own numbers, open the live Maintenance Interval calculator, set setup, handling, and delay allowance to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.