Nonwoven Materials & Technical Textiles worked example

Changeover Time at 7.2% setup, threading, and purge allowance: a worked example in nonwoven materials & technical textiles

This worked example runs the changeover time numbers for a tougher week than the baseline: 7.2% setup, threading, and purge allowance instead of the typical 10%. Estimate changeover time for nonwoven materials and technical textiles using production-ready inputs so teams can plan labor hours, schedule the work, or check whether the job fits the available shift time.

The inputs for this scenario

  • Rolls or units to process in the changeover batch: 120 units (held at the documented default)
  • Line throughput rate during changeover run: 12 units / min (held at the documented default)
  • Setup, threading, and purge allowance: 7.2 % (the input this scenario stresses; the baseline uses 10)

Working through the calculation

  • The calculation starts from the formula this tool documents: Base changeover time = changeover time workload รท changeover time completion rate.
  • Required changeover time works out to 10.72 hr at these inputs, and this is the headline figure for the scenario.
  • Base changeover time works out to 10 hr at these inputs.
  • Changeover time allowance applied works out to 7.2 % at these inputs.
  • Changeover time completion rate works out to 12 pieces / min at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where setup, threading, and purge allowance sits at 10% and the headline result is 11 hr, this scenario comes in 2.55% below the baseline at 10.72 hr.
  • Use it when scheduling a grade change, quoting a job that needs a switchover, or setting a baseline before a SMED improvement effort. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Required changeover time: 10.72 hr (headline result)
  • Base changeover time: 10 hr
  • Changeover time allowance applied: 7.2 %
  • Changeover time completion rate: 12 pieces / min

Run it with your numbers

  • To rerun this with your own numbers, open the live Changeover Time calculator, set setup, threading, and purge allowance to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.