Plating, Anodizing & Surface Treatment worked example

Plating Cost per Part at 68% deposit acceptance rate: a worked example

Suppose deposit acceptance rate falls to 68%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate plating cost per part from the area plated, per-square-foot rate, deposit acceptance, and flat strike or racking adders.

The inputs for this scenario

  • Plated surface area per part: 1.8 sq ft (held at the documented default)
  • Plating price per square foot: 5.4 $/sq ft (held at the documented default)
  • Deposit acceptance rate: 68 % (the input this scenario stresses; the baseline uses 94)
  • Strike and rack setup adder: 2 $ (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Plating cost = area x cost per square foot x acceptance% + strike and rack adder.
  • Total plating cost per part cost works out to 8.61 $ at these inputs, and this is the headline figure for the scenario.
  • Plating cost per part cost per unit works out to 4.78 $ / piece at these inputs.
  • Variable plating cost per part cost works out to 6.61 $ at these inputs.
  • Fixed plating cost per part adder works out to 2 $ at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where deposit acceptance rate sits at 94% and the headline result is 11.14 $, this scenario comes in 22.69% below the baseline at 8.61 $.
  • It multiplies plated area by the price per square foot, factors in deposit acceptance, adds the strike and rack setup, and divides by area to give a per-part cost. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Total plating cost per part cost: 8.61 $ (headline result)
  • Plating cost per part cost per unit: 4.78 $ / piece
  • Variable plating cost per part cost: 6.61 $
  • Fixed plating cost per part adder: 2 $

Run it with your numbers

  • To rerun this with your own numbers, open the live Plating Cost per Part calculator, set deposit acceptance rate to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.