Finishing worked example
Powder Cure Window with measured cure value of 6 min or °F: a worked example
Suppose measured cure value falls to 6 min or °F. This page works the full calculation at that level so you can see exactly which result moves and by how much. Check whether actual part metal temperature or cure time is inside the powder cure window.
The inputs for this scenario
- Measured cure value (peak metal temp or dwell): 6 min or °F (the input this scenario stresses; the baseline uses 12)
- Minimum cure spec limit: 10 min or °F (held at the documented default)
- Maximum cure spec limit: 18 min or °F (held at the documented default)
Working through the calculation
- The calculation starts from the formula this tool documents: Inside window when actual value is between minimum and maximum.
- Inside window works out to 0 outside at these inputs, and this is the headline figure for the scenario.
- Nearest margin works out to -4 value at these inputs.
- Lower limit works out to 10 value at these inputs.
- Upper limit works out to 18 value at these inputs.
How this compares with the baseline
- Against the tool's baseline example, where measured cure value sits at 12 min or °F and the headline result is 1 inside, this scenario comes in 100% below the baseline at 0 outside.
- It reports whether a measured cure value sits between the minimum and maximum spec limits and the nearest distance to either limit. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.
Results at a glance
- Inside window: 0 outside (headline result)
- Nearest margin: -4 value
- Lower limit: 10 value
- Upper limit: 18 value
Run it with your numbers
- To rerun this with your own numbers, open the live Powder Cure Window calculator, set measured cure value to your actual value, and adjust the remaining inputs to match your operation.
Last reviewed 2026-05-12.