Printed Electronics & Flexible Hybrid Electronics worked example
Lamination Yield at 99% lamination yield target: a worked example in printed electronics & flexible hybrid electronics
This scenario runs the lamination yield calculation on the strong side: 99% lamination yield target, with every other input held at its documented default. Use it when lamination yield in printed electronics and flexible hybrid electronics needs a clean rate and gap-to-target you can put on a tier board.
The inputs for this scenario
- Delaminated or failed laminated pieces: 8 units (unchanged)
- Total pieces laminated in the batch: 250 units (unchanged)
- Lamination yield target: 99 % (raised for this scenario; the documented default is 95)
Working through the calculation
- Applying the documented formula (Lamination Yield rate = affected amount รท total amount) to the inputs above produces each figure below.
- At this operating point the engine returns 3.2 % for rate, the number this scenario is built around.
- At this operating point the engine returns 95.8 points for gap to target.
- At this operating point the engine returns 8 count for affected count.
- At this operating point the engine returns 250 count for total count.
How this compares with the baseline
- Against the tool's baseline example, where lamination yield target sits at 95% and the headline result is 3.2 %, this scenario lands almost exactly on the baseline at 3.2 %.
- Use it after a lamination run to log defect rate, or during a shift to check whether the station is drifting against its yield target. Treat this as a target state: the delta against the baseline quantifies what the improvement is worth before you commit to chasing it.
Results at a glance
- Rate: 3.2 % (headline result)
- Gap to target: 95.8 points
- Affected count: 8 count
- Total count: 250 count
Run it with your numbers
- Every input above is editable in the live Lamination Yield calculator, which recalculates instantly and can be shared with the inputs intact.
Last reviewed 2026-05-12.