Pump, Compressor & Rotating Equipment Assembly worked example

Warranty Exposure with field-failure severity of the assembled unit of 3 score: a worked example in pump, compressor & rotating equipment assembly

This worked example runs the warranty exposure numbers for a tougher week than the baseline: field-failure severity of the assembled unit of 3 score instead of the typical 6 score. Warranty Exposure translates the three FMEA dimensions of a rotating-equipment defect into a single weighted risk score.

The inputs for this scenario

  • Field-failure severity of the assembled unit (1-10): 3 score (the input this scenario stresses; the baseline uses 6)
  • Likelihood of the defect occurring per build (1-10): 4 score (held at the documented default)
  • Likelihood the defect escapes final test undetected (1-10): 3 score (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Warranty Exposure risk score = severity × 0.40 + occurrence × 0.35 + detection × 0.25.
  • Risk score works out to 3.35 score at these inputs, and this is the headline figure for the scenario.
  • Severity works out to 3 score at these inputs.
  • Occurrence works out to 4 score at these inputs.
  • Detection works out to 3 score at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where field-failure severity of the assembled unit sits at 6 score and the headline result is 4.55 score, this scenario comes in 26.37% below the baseline at 3.35 score.
  • Use it when ranking failure modes during a design or process FMEA, or when setting warranty reserves for a new pump or compressor line. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Risk score: 3.35 score (headline result)
  • Severity: 3 score
  • Occurrence: 4 score
  • Detection: 3 score

Run it with your numbers

  • To rerun this with your own numbers, open the live Warranty Exposure calculator, set field-failure severity of the assembled unit to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.