Rare Earth Magnet & Motor Materials worked example

Production Ramp Planner at 65% expected equipment uptime: a worked example in rare earth magnet & motor materials

This worked example runs the production ramp planner numbers for a tougher week than the baseline: 65% expected equipment uptime instead of the typical 90%. Estimate production ramp planner for rare earth magnet and motor materials using production-ready inputs so teams can confirm whether capacity can cover demand before committing the schedule.

The inputs for this scenario

  • Magnets pressed per sinter cycle: 4 units / cycle (held at the documented default)
  • Sinter cycles available in the plan window: 480 cycles (held at the documented default)
  • Expected equipment uptime: 65 % (the input this scenario stresses; the baseline uses 90)
  • Expected first-pass yield: 97 % (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Gross production ramp planner capacity = production ramp planner output per cycle × available production ramp planner cycles.
  • Good production ramp planner capacity works out to 1,211 units at these inputs, and this is the headline figure for the scenario.
  • Gross production ramp planner capacity works out to 1,920 units at these inputs.
  • Production ramp planner downtime loss works out to 672 units at these inputs.
  • Production ramp planner yield loss works out to 37.44 units at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where expected equipment uptime sits at 90% and the headline result is 1,676 units, this scenario comes in 27.78% below the baseline at 1,211 units.
  • Use it during a new-line or new-product ramp to set deliverable commitments before the process is fully mature. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Good production ramp planner capacity: 1,211 units (headline result)
  • Gross production ramp planner capacity: 1,920 units
  • Production ramp planner downtime loss: 672 units
  • Production ramp planner yield loss: 37.44 units

Run it with your numbers

  • To rerun this with your own numbers, open the live Production Ramp Planner calculator, set expected equipment uptime to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.