Refractories, Furnace Linings & Foundry Consumables worked example

Heat-Up Schedule Duration at 12% soak and hold-time allowance: a worked example

This scenario runs the heat-up schedule duration calculation on the strong side: 12% soak and hold-time allowance, with every other input held at its documented default. Use it when heat-up schedule duration in refractories, furnace linings and foundry consumables is changing rate or allowance and you want to see the impact.

The inputs for this scenario

  • Total refractory mass or thickness to cure: 120 units (unchanged)
  • Controlled ramp rate (cure throughput): 12 units / hr (unchanged)
  • Soak and hold-time allowance: 12 % (raised for this scenario; the documented default is 10)

Working through the calculation

  • Applying the documented formula (Base heat-up schedule duration time = required work รท processing rate) to the inputs above produces each figure below.
  • At this operating point the engine returns 11.2 hr for adjusted run time, the number this scenario is built around.
  • At this operating point the engine returns 10 hr for base run time.
  • At this operating point the engine returns 12 % for allowance applied.
  • At this operating point the engine returns 12 pieces / min for process rate.

How this compares with the baseline

  • Against the tool's baseline example, where soak and hold-time allowance sits at 10% and the headline result is 11 hr, this scenario comes in 1.82% above the baseline at 11.2 hr.
  • Use it when planning the dry-out window for a new or repaired monolithic refractory lining before returning a furnace to service. Treat this as a target state: the delta against the baseline quantifies what the improvement is worth before you commit to chasing it.

Results at a glance

  • Adjusted run time: 11.2 hr (headline result)
  • Base run time: 10 hr
  • Allowance applied: 12 %
  • Process rate: 12 pieces / min

Run it with your numbers

  • Every input above is editable in the live Heat-Up Schedule Duration calculator, which recalculates instantly and can be shared with the inputs intact.

Last reviewed 2026-05-12.