Renewable Energy, Solar & Wind Manufacturing worked example

Wind Blade Mold Utilization at 68% target mold utilization rate: a worked example

This worked example runs the wind blade mold utilization numbers for a tougher week than the baseline: 68% target mold utilization rate instead of the typical 95%. Estimate wind blade mold utilization for renewable energy, solar and wind manufacturing using production-ready inputs so teams can track KPI performance and decide whether corrective action is needed.

The inputs for this scenario

  • Molds actively in production: 8 count (held at the documented default)
  • Total molds in the fleet: 250 count (held at the documented default)
  • Target mold utilization rate: 68 % (the input this scenario stresses; the baseline uses 95)

Working through the calculation

  • The calculation starts from the formula this tool documents: Wind blade mold utilization rate = wind blade mold utilization count ÷ total wind blade mold utilization population × 100.
  • Wind blade mold utilization rate works out to 3.2 % at these inputs, and this is the headline figure for the scenario.
  • Wind blade mold utilization gap to target works out to 64.8 points at these inputs.
  • Wind blade mold utilization count works out to 8 count at these inputs.
  • Total wind blade mold utilization population works out to 250 count at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where target mold utilization rate sits at 95% and the headline result is 3.2 %, this scenario lands almost exactly on the baseline at 3.2 %.
  • Use it during weekly production planning, capex reviews, or when a customer campaign ends and molds go idle awaiting the next order. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Wind blade mold utilization rate: 3.2 % (headline result)
  • Wind blade mold utilization gap to target: 64.8 points
  • Wind blade mold utilization count: 8 count
  • Total wind blade mold utilization population: 250 count

Run it with your numbers

  • To rerun this with your own numbers, open the live Wind Blade Mold Utilization calculator, set target mold utilization rate to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.