Switchgear, Panelboards & Electrical Distribution worked example

Terminal Count Labor at 92% standard-time efficiency factor: a worked example

What does the result look like when standard-time efficiency factor reaches 92%? The full calculation is worked below with real intermediate numbers. Use it when terminal count labor in switchgear, panelboards and electrical distribution is being put through a switchgear, panelboards and electrical distribution weighted-cost review.

The inputs for this scenario

  • Total terminations to land: 100 units (unchanged)
  • Labor cost per termination: 45 $ / unit (unchanged)
  • Standard-time efficiency factor: 92 % (raised for this scenario; the documented default is 80)
  • Fixed setup & prep labor cost: 250 $ (unchanged)

Working through the calculation

  • Applying the documented formula (Terminal Count Labor cost = quantity × rate × capture factor + fixed cost) to the inputs above produces each figure below.
  • At this operating point the engine returns 4,390 $ for weighted cost, the number this scenario is built around.
  • At this operating point the engine returns 43.9 $ / piece for per piece value.
  • At this operating point the engine returns 4,140 $ for captured value.
  • At this operating point the engine returns 250 $ for fixed adjustment.

How this compares with the baseline

  • Against the tool's baseline example, where standard-time efficiency factor sits at 80% and the headline result is 3,850 $, this scenario comes in 14.03% above the baseline at 4,390 $.
  • A figure at this level is achievable when standard-time efficiency factor is genuinely sustained, not just peaked for a shift. It treats all terminations as equal; a fine-strand control landing and a 500 kcmil lug termination cost very different labor, so blend your cost-per-termination accordingly.

Results at a glance

  • Weighted cost: 4,390 $ (headline result)
  • Per piece value: 43.9 $ / piece
  • Captured value: 4,140 $
  • Fixed adjustment: 250 $

Run it with your numbers

  • Every input above is editable in the live Terminal Count Labor calculator, which recalculates instantly and can be shared with the inputs intact.

Last reviewed 2026-05-12.