Trailers, Truck Bodies & Specialty Vehicles worked example

Door Hardware Labor at 58% billable-time capture factor: a worked example

Suppose billable-time capture factor falls to 58%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Door hardware labor is the fully-loaded cost of installing and aligning the hinges, latches, cam locks, hold-backs and seals on trailer and truck-body doors.

The inputs for this scenario

  • Doors or hinge/latch sets installed: 100 units (held at the documented default)
  • Labor rate per hardware set: 45 $ / unit (held at the documented default)
  • Billable-time capture factor: 58 % (the input this scenario stresses; the baseline uses 80)
  • Fixed setup and consumables cost: 250 $ (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Door Hardware Labor cost = quantity × rate × capture factor + fixed cost.
  • Weighted cost works out to 2,860 $ at these inputs, and this is the headline figure for the scenario.
  • Per piece value works out to 28.6 $ / piece at these inputs.
  • Captured value works out to 2,610 $ at these inputs.
  • Fixed adjustment works out to 250 $ at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where billable-time capture factor sits at 80% and the headline result is 3,850 $, this scenario comes in 25.71% below the baseline at 2,860 $.
  • It computes total door hardware installation labor cost and the per-door labor cost from a unit count, labor rate, billable capture factor, and a fixed cost. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Weighted cost: 2,860 $ (headline result)
  • Per piece value: 28.6 $ / piece
  • Captured value: 2,610 $
  • Fixed adjustment: 250 $

Run it with your numbers

  • To rerun this with your own numbers, open the live Door Hardware Labor calculator, set billable-time capture factor to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.