UAV & Drone Manufacturing worked example

Regulatory Documentation Load with certification test rig connected load of 6 kW: a worked example

This worked example runs the regulatory documentation load numbers for a tougher week than the baseline: certification test rig connected load of 6 kW instead of the typical 12 kW. Estimate regulatory documentation load for uav and drone manufacturing using production-ready inputs so teams can budget energy cost, compare equipment settings, or include electricity in the quote.

The inputs for this scenario

  • Certification test rig connected load: 6 kW (the input this scenario stresses; the baseline uses 12)
  • Documentation test runtime: 8 hr (held at the documented default)
  • Blended electricity rate: 0.12 $ / kWh (held at the documented default)
  • Drones documented during runtime: 1,000 units (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Total regulatory documentation load energy cost = regulatory documentation load connected load × regulatory documentation load runtime × blended electricity rate.
  • Regulatory documentation load energy used works out to 48 kWh at these inputs, and this is the headline figure for the scenario.
  • Total regulatory documentation load energy cost works out to 5.76 $ at these inputs.
  • Energy cost per kWh works out to 0.01 $ / piece at these inputs.
  • Hourly regulatory documentation load energy cost works out to 0.72 $ / hr at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where certification test rig connected load sits at 12 kW and the headline result is 96 kWh, this scenario comes in 50% below the baseline at 48 kWh.
  • Use it when costing a certification campaign, allocating test-lab energy to a program, or comparing the running cost of two documentation test setups. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Regulatory documentation load energy used: 48 kWh (headline result)
  • Total regulatory documentation load energy cost: 5.76 $
  • Energy cost per kWh: 0.01 $ / piece
  • Hourly regulatory documentation load energy cost: 0.72 $ / hr

Run it with your numbers

  • To rerun this with your own numbers, open the live Regulatory Documentation Load calculator, set certification test rig connected load to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.