Waste-to-Energy Equipment worked example

Project Margin with contract revenue or realized price of 63 value: a worked example in waste-to-energy equipment

This worked example runs the project margin numbers for a tougher week than the baseline: contract revenue or realized price of 63 value instead of the typical 125 value. Estimate project margin for waste-to-energy equipment using production-ready inputs so teams can measure the gap between available and required amounts.

The inputs for this scenario

  • Contract revenue or realized price: 63 value (the input this scenario stresses; the baseline uses 125)
  • Fully-loaded project cost: 100 value (held at the documented default)
  • Revenue basis for margin: 100 value (held at the documented default)

Working through the calculation

  • The calculation starts from the formula this tool documents: Project margin amount gap = available project margin amount - required project margin amount.
  • Project margin works out to -37 % at these inputs, and this is the headline figure for the scenario.
  • Project margin amount gap works out to -37 value at these inputs.
  • Available project margin amount works out to 63 value at these inputs.
  • Required project margin amount works out to 100 value at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where contract revenue or realized price sits at 125 value and the headline result is 25 %, this scenario comes in 248% below the baseline at -37 %.
  • Use it at bid time, at project handover, and in post-mortems to compare estimated versus actual margin. A result at this level usually justifies acting on the stressed input before touching anything else, because every other figure in the table is downstream of it.

Results at a glance

  • Project margin: -37 % (headline result)
  • Project margin amount gap: -37 value
  • Available project margin amount: 63 value
  • Required project margin amount: 100 value

Run it with your numbers

  • To rerun this with your own numbers, open the live Project Margin calculator, set contract revenue or realized price to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.