Workforce, Labor Standards & Skills Planning worked example

Standard Minutes Per Unit at 9.2% utilization target: a worked example

What does the result look like when utilization target reaches 9.2%? The full calculation is worked below with real intermediate numbers. Use it when standard minutes per unit in workforce, labor standards and skills planning is being sized against an asset rating.

The inputs for this scenario

  • Order demand to be produced: 100 units (unchanged)
  • Line capacity per hour: 1.2 units (unchanged)
  • Utilization target: 9.2 % (raised for this scenario; the documented default is 8)

Working through the calculation

  • Applying the documented formula (Required standard minutes per unit load = standard minutes per unit demand รท standard minutes per unit utilization target) to the inputs above produces each figure below.
  • At this operating point the engine returns 120 hr for total load, the number this scenario is built around.
  • At this operating point the engine returns 13.04 hr / hr for hourly equivalent.
  • At this operating point the engine returns 100 hr for input load.
  • At this operating point the engine returns 1.2 x for load factor.

How this compares with the baseline

  • Against the tool's baseline example, where utilization target sits at 8% and the headline result is 120 hr, this scenario lands almost exactly on the baseline at 120 hr.
  • A figure at this level is achievable when utilization target is genuinely sustained, not just peaked for a shift. It treats demand, capacity, and utilization as single steady values; it does not model changeovers, product mix, or ramp-up within the period.

Results at a glance

  • Total load: 120 hr (headline result)
  • Hourly equivalent: 13.04 hr / hr
  • Input load: 100 hr
  • Load factor: 1.2 x

Run it with your numbers

  • Every input above is editable in the live Standard Minutes Per Unit calculator, which recalculates instantly and can be shared with the inputs intact.

Last reviewed 2026-05-12.