Vending, Kiosk & Self-Service Equipment worked example

Touchscreen Calibration Time at 7.2% setup, retest, and handling allowance: a worked example

Suppose setup, retest, and handling allowance falls to 7.2%. This page works the full calculation at that level so you can see exactly which result moves and by how much. Estimate touchscreen calibration time for vending, kiosk and self-service equipment using production-ready inputs so teams can plan labor hours, schedule the work, or check whether the job fits the available shift time.

The inputs for this scenario

  • Touchscreens to calibrate: 120 units (held at the documented default)
  • Calibration throughput per station: 12 units / min (held at the documented default)
  • Setup, retest, and handling allowance: 7.2 % (the input this scenario stresses; the baseline uses 10)

Working through the calculation

  • The calculation starts from the formula this tool documents: Base touchscreen calibration time = touchscreen calibration time workload รท touchscreen calibration time completion rate.
  • Required touchscreen calibration time works out to 10.72 hr at these inputs, and this is the headline figure for the scenario.
  • Base touchscreen calibration time works out to 10 hr at these inputs.
  • Touchscreen calibration time allowance applied works out to 7.2 % at these inputs.
  • Touchscreen calibration time completion rate works out to 12 pieces / min at these inputs.

How this compares with the baseline

  • Against the tool's baseline example, where setup, retest, and handling allowance sits at 10% and the headline result is 11 hr, this scenario comes in 2.55% below the baseline at 10.72 hr.
  • It computes base calibration time (screens divided by throughput) and then the required time after applying a setup and retest allowance percentage. When the numbers land here, the stressed input is the lever to work; the walkthrough above shows exactly how much each output recovers as it climbs back toward the baseline.

Results at a glance

  • Required touchscreen calibration time: 10.72 hr (headline result)
  • Base touchscreen calibration time: 10 hr
  • Touchscreen calibration time allowance applied: 7.2 %
  • Touchscreen calibration time completion rate: 12 pieces / min

Run it with your numbers

  • To rerun this with your own numbers, open the live Touchscreen Calibration Time calculator, set setup, retest, and handling allowance to your actual value, and adjust the remaining inputs to match your operation.

Last reviewed 2026-05-12.