Wire, Cable & Conductor Manufacturing worked example
Spool Capacity at 99% line uptime: a worked example
Push line uptime up to 99% and the picture changes. This example computes every intermediate figure at that operating point. Use it when spool capacity in wire, cable and conductor manufacturing is being asked to take on more work and you need to know if there is room.
The inputs for this scenario
- Length wound per take-up cycle: 4 units / cycle (unchanged)
- Take-up cycles available in the period: 480 cycles (unchanged)
- Line uptime: 99 % (raised for this scenario; the documented default is 90)
- Good-length yield: 97 % (unchanged)
Working through the calculation
- Applying the documented formula (Gross spool capacity capacity = units per cycle × available cycles) to the inputs above produces each figure below.
- At this operating point the engine returns 1,844 units for good output capacity, the number this scenario is built around.
- At this operating point the engine returns 1,920 units for gross capacity.
- At this operating point the engine returns 19.2 units for uptime loss.
- At this operating point the engine returns 57.02 units for yield loss.
How this compares with the baseline
- Against the tool's baseline example, where line uptime sits at 90% and the headline result is 1,676 units, this scenario comes in 10% above the baseline at 1,844 units.
- It computes gross capacity from length per cycle and available cycles, then discounts by uptime and yield to give good, shippable output. The value of this scenario is the size of the gap it exposes: that gap, priced out over a year, is the budget you can justify spending to close it.
Results at a glance
- Good output capacity: 1,844 units (headline result)
- Gross capacity: 1,920 units
- Uptime loss: 19.2 units
- Yield loss: 57.02 units
Run it with your numbers
- Every input above is editable in the live Spool Capacity calculator, which recalculates instantly and can be shared with the inputs intact.
Last reviewed 2026-05-12.